Manufacturer/Support

MicroWerks, Inc.
P.O. Box 768273
Roswell, GA. 30076-8273
404-410-9358 - Support BBS
72510,1766 - CompuServe

Microlink v1.05 for Windows:
DIP Switches: 3, 5, and 8 DOWN (ON)

CHANGE PORT:  Pull down the "Settings" menu, and select "Port". From
              this screen you can change the port settings, baud rate,
              flow control, and line settings. There is also a checkbox 
              marked "Locked Baud Rate". Make sure this is checked.

CHANGE IRQ:  This program uses the settings in the Windows Control
             Panel.

INIT STRING:  Pull down the "Settings" menu and select "Modem".

              Note:  Do not place an "AT" in front of the init string. 
                     This is incorporated into the dial prefix instead 
                     of sending it as a separate command. Set the 
                     initialization string to the following:
                     &F&B1&H1&R2&A3&K3X4S11=40.

              Note:  Here is an example of how the program dials out, 
                     which explains the reason for leaving out the "AT" 
                      at the start of the init string. If you were to 
                      specify an init string of
                      "&F&B1&H1&R2&A3&K3X4S11=40", the software would 
                      dial AT&F&B1&H1&R2&A3&K3X4S11=40DT {number}

TERMINAL MODE:  The program begins in terminal mode.

Notes:  Select U.S. Robotics from the modem list during installation.
        There are no specific models listed, just company names. Make 
        sure you have the port speed set to 19200 for our 14.4k modems, 
        and 38400 if you are operating a v.FC or later model. Also make
        sure you are using Hardware Flow Control, and that the Lock Baud 
        Rate box is checked in the Settings->Port dialog box.