Installing an ISA Bus Modem in an EISA Bus Slot

To use your U.S. Robotoics modem in an EISA bus slot, you need to
select the "Generic ISA Adaptor" definition for our modems.  Below are
the instructions recommended by Compaq for doing this on their
systems:

  *  Select "Configure Computer"(Check your system manual for
     instructions on where to find this on your system)
  *  Select "Add/Remove" boards
  *  Highlight the slot the ISA card is using and press <Enter>
  *  There will be a menu with these selections:
       *  Compaq card
       *  Non-Compaq card
       *  Board without a configuration file
  *  Select "Board without a configuration file"
  *  Insert "Non-Compaq Options Diskette"(Check with Compaq if you 
     do not have one) when prompted to do so.
  *  Select "Generic ISA Adapter Definition"
  *  Verify that you've selected the right slot and press <Enter>.
  *  Press <F10> for done.
  *  Select View or Edit details from the menu. You'll see a 
     summary of the system configuration including the slot which 
     was just configured
  *  Highlight and configure the Port Base Address(es), Address
     ranges, IRQs, and so forth.
  *  Press <F10> when done and select Save and Exit.
  *  The machine will reboot and the ISA card will be available.

If this installation will be done on a non-Compaq system, the
procedure may vary, but should be similar.