- Right-click Network Neighborhood and go to Properties.
Select the Services tab (see Figure 1).
Figure 1 - Click Add.
- Select Have Disk (see Figure 2).
Figure 2
4. Type in the path to the location of the
Digi EtherLite driver that has been extracted (see
Figure 3). Click Ok.
Figure 3
5. Select the Digi
RealPort Service option and Click Ok (see Figure 4).
Figure 4
6. You will need to configure
an IP address for the EtherLite before installing the driver.
If you
have not already done so, select the DgIpServ button and step through the
Store
IP Settings wizard. After you have finished assigning the IP address, you
will come
back to
this screen (see Figure 5). Enter the IP address you assigned to the
EtherLite.
NOTE:
Leave the TCP port set to 771
Figure 5
7. Give the EtherLite a name and
specify the number of ports you want to add (see Figure 6).
Figure 6
8. You will now get a
message that x number of ports have been configured and allow you to change the
port names (see
Figure 7).
Figure 7
9. You should now get the EtherLite
configuration screen showing the com ports the EtherLite will be assigned (see
Figure 8).
Figure 8
10. Click Finish.
11. It will now prompt you to
start the Digi RealPort Service (see Figure 9).
Figure 9
12. The services will now bind and you will have to reboot before using the EtherLite.