Windows Telnet with PortServer (II or TS) results in double CR/LF and a failure to login


	Technical Support Drivers Firmware Upgrades FAQs Product Documentation Cabling Support Tools Legacy Products About Digi Support Knowledge Base Online Support Request FTP Site Related Links Inside Out Networks

Home > Support >kbase >

Windows Telnet with PortServer (II or TS) results in double CR/LF and a failure to login Windows Telnet with PortServer (II or TS) results in double CR/LF and a failure to login

Symptom:

Telnetting into the PortServer (II or TS) is successful, but you may get double CR/LF so the device on the end of the serial port sees 2 CRs and login fails.

Cause:

This is a known issue with Windows Telnet Client.

Solutions:

If you use a different telnet client the double CR/LF issue should be resolved and a login should be successful.

On the TS product line (not on the Portserver II) you can enable the following:

set telnetip ip=IP_ADDRESS mask=MASK_VALUE mode=striplf