ETHERLITE REALPORT DRIVER INSTALLATION UNDER WINDOWS NT


	Technical Support Drivers Firmware Upgrades FAQs Product Documentation Cabling Support Tools Legacy Products About Digi Support Knowledge Base Online Support Request FTP Site Related Links Inside Out Networks

Home > Support >kbase >

ETHERLITE REALPORT DRIVER INSTALLATION UNDER WINDOWS NT ETHERLITE REALPORT DRIVER INSTALLATION UNDER WINDOWS NT

Right-click Network Neighborhood and go to Properties. Select the Services tab.
Click Add.
Select Have Disk.

   4.    Type in the path to the location of the Digi EtherLite driver that has been extracted. Click Ok.

    5.    Select the Digi RealPort Service option and Click Ok.



    6.    You will need to configure an IP address for the EtherLite before installing the driver.
           If you have not already done so, select the DgIpServ button and step through the
           Store IP Settings wizard. After you have finished assigning the IP address, you will come
           back to this screen. Enter the IP address you assigned to the EtherLite.
            NOTE: Leave the TCP port set to 771

    7.   Give the EtherLite a name and specify the number of ports you want to add.

    8.    You will now get a message that x number of ports have been configured and allow you to change the port names.

    9.    You should now get the EtherLite configuration screen showing the com ports the EtherLite will be assigned.

10. Click Finish.

11. It will now prompt you to start the Digi RealPort Service.

12. The services will now bind and you will have to reboot before using the EtherLite.