How do you configure the ISA Classic board for Digi emulation mode?


	Technical Support Drivers Firmware Upgrades FAQs Product Documentation Cabling Support Tools Legacy Products About Digi Support Knowledge Base Online Support Request FTP Site Related Links Inside Out Networks

Home > Support >kbase >

How do you configure the ISA Classic board for Digi emulation mode? How do you configure the ISA Classic board for Digi emulation mode?

Run the Classic CFG utility from a clean DOS boot

Select F3 to Edit New Profile

Select "No" for PnP Mode

Select "Digi" for Control Register Int Mode. Once this is complete, select a unique I/O value and IRQ for the Control Register, and a unique I/O address for each port on the board. For most systems, it is recommended that you avoid I/O addresses in the 100 range.

A sample configuration for a Classic 8 would be:

Control Register Int mode: Digi I/O: 260 IRQ: 5 Port I/O Addresses: 220, 228, 230, 238, 240, 248, 250, 258

Once you have made your selections, complete the configuration by following these steps:

Select F5 to Write New Profile to Board

Select F6 to Write New Profile to Disk

Select and name the profile you created

Select F10 to Exit