How do you configure the ISA Classic board for Plug and Play mode?


	Technical Support Drivers Firmware Upgrades FAQs Product Documentation Cabling Support Tools Legacy Products About Digi Support Knowledge Base Online Support Request FTP Site Related Links Inside Out Networks

Home > Support >kbase >

How do you configure the ISA Classic board for Plug and Play mode? How do you configure the ISA Classic board for Plug and Play mode?

The Classic board ships from the factory set for Plug and Play mode by default, but if that has been changed, follow the steps below to configure the board for Plug and Play mode.

Run the Classic CFG utility from a clean DOS boot

Select F3 to Edit New Profile

Select "Yes" for PnP Mode

Select F5 to Write New Profile to Board

Select F6 to Write New Profile to Disk

Select and name the profile you created

Select F10 to Exit