1. Go to Control Panel and select the Add/Remove Hardware Wizard (see Figure 1).
   
                                                                                                                                                      Figure 1
2. At the Welcome to the Add Hardware Wizards screen, click Next (see Figure 2).
   
                                                                                                                    Figure 2
   
   
3. Select the option to Yes, I have already connected the hardware (see Figure 3).  Click Next.
   
                                                                                                                    Figure 3

   4.    Select the option to Add a new hardware device (see Figure 4).  Click Next.
         
                                                                                                                           Figure 4

    5.    Select the option to install the hardware that I manually select from a list (see Figure 5).  Click Next.
          
                                                                                                                            Figure 5

    6.    Select Multi-port Serial Adapter from the list of Hardware Types (see Figure 6).  Click Next.
           
                                                                                                                             Figure 6

    7.   Select Digi International for the Manufacturer and Digi PortServer for the Model (see Figure 7).
         
                                                                                                                            Figure 7

    8.    You will get a message showing you the hardware that is about to be installed (see Figure 8).  Click Next.
          
                                                                                                                            Figure 8

    9.    You will need to configure an IP address for the EtherLite before loading the driver.  If you have not already done so, select the DgIpServ 
           button and step through the Store IP Settings wizard.  After you have finished assigning the IP address, you will come back to this screen 
           (see Figure 9).  Enter the IP address you assigned to the EtherLite.  NOTE: Leave the TCP port set to 771
          
                                                                                                             Figure 9

   10.   Give the EtherLite a name and specify the number of ports you want to add (see Figure 10).
           
                                                                                                            Figure 10
                                                                                                                        

   11.   You should now get the EtherLite configuration screen showing the com ports the EtherLite will be assigned (see Figure 11).
          
                                                                                                           Figure 11
            
                                                                                                             

   12.    Click Finish (see Figure 12).
           
                                                                                                                           Figure 12

   13.    Your EtherLite should now show up under Device Manger, Multi-port Serial Adapters and the com ports added under Ports.