1. Go to Control Panel and select the Add/Remove Hardware Wizard (see Figure 1).
   
                                                                                                                                                      Figure 1
2. At the Welcome to the Add Hardware Wizards screen, click Next (see Figure 2).
   
                                                                                                                    Figure 2
   
   
3. Select the option to Yes, I have already connected the hardware (see Figure 3).  Click Next.
   
                                                                                                                    Figure 3

   4.    Select the option to Add a new hardware device (see Figure 4).  Click Next.
         
                                                                                                                           Figure 4

    5.    Select the option to install the hardware that I manually select from a list (see Figure 5). 
Click Next.
          
                                                                                                                            Figure 5

    6.    Select Multi-port Serial Adapter from the list of Hardware Types (see Figure 6).  Click Next.
           
                                                                                                                             Figure 6

    7.   Select Digi International for the Manufacturer and Digi PortServer for the Model (see Figure 7).
         
                                                                                                                            Figure 7

    8.    You will get a message showing you the hardware that is about to be installed (see Figure 8). 
Click Next.
          
                                                                                                                            Figure 8

    9.    Enter the IP Address you configured the PortServer (II or TS) hardware with prior to
loading the driver.  If you have not already done so, you will need to go back and do that.& 
           nbsp; NOTE: Leave the TCP port set to 771 (see Figure 9).  Click Next.
          
                                                                                                             Figure 9

   10.   Give the PortServer (II or TS) a name and specify the number of ports you want to add
(see Figure 10).
           
                                                                                                            Figure 10
                                                                                                                        

   11.   You should now get the PortServer (II or TS) configuration screen showing the com ports the PortServer (II or TS) will be assigned (see Figure 11). 
          
          
                                                                                                           Figure 11
            
                                                                                                             

   12.    Click Finish (see Figure 12).
           
                                                                                                                           Figure 12

   13.    Your PortServer (II or TS) should now show up under Device Manger, Multi-port Serial Adapters
and the com ports added under Ports.