|
Testing Digi AccelePort Adapter ports or modems in Novell Netware Testing Digi AccelePort Adapter ports or modems in Novell Netware
Symptom:
Unable to communicate through the Digi AccelePort board in a Novell Netware Server.
Cause:
The driver may not have loaded properly or may have a potential conflict.
Solution:
To verify that everything is configured properly:
1. Verify when you load the driver that it reports "X channels initialized successfully."
Note: X is the number of ports on your adapter.
For example, if you have an 8 port board, it should say 8 channels initialized
successfully.
2. Go into terminal mode, either through NIAS or AIOTERM and see if you are
able to access the port.
If you have a modem on the port, you should be able
to type AT and get an OK back from the modem.
If you do not have a modem on the port, plug the
loopback into the port and you should be able to type on the keyboard and see it
display
on the screen. If you do, the Digi AccelePort is
installed and working properly.
|
