
Technical Support

•	drivers
•	firmware upgrades
•	FAQs
•	product documentation
•	cabling
•	support tools
•	legacy products
•	about digi support
•	knowledge base
•	online support request
•	support feedback
•	support feedback
•	FTP site
•	inside out networks

How to set the PortServer or PortServer II back to factory defaults.


	Technical Support Drivers Firmware Upgrades FAQs Product Documentation Cabling Support Tools Legacy Products About Digi Support Knowledge Base Online Support Request FTP Site Related Links Inside Out Networks

Home > Support >kbase >

How to set the PortServer or PortServer II back to factory defaults. How to set the PortServer or PortServer II back to factory defaults.

To set the PortServer or PortServer II back to factory defaults, hold both the left and right arrows on the front panel down. Turn the power switch on the PortServer/PortServer II module OFF and then ON. Watch for "EP" on the PortServer or "CL" on the PortServer II to appear on the front panel display, then release the left and right arrow buttons.