Testing a Port

Use this procedure to test a Digi port.

1. Disable login (if it is enabled) and any other services or processes open on the port.

2. Perform one or more of the following tests on the port. 

   Test	Description
   Basic Loopback Test See Testing a Port with a Loopback Plug.	This test sends information through a loopback plug and back to the console. It tests the ports ability to transmit and receive data.
   Dumb Terminal Echo Test See Testing a Port with a Dumb Terminal.	This test sends information to a dumb terminal attached to the port.  It tests the port's ability to transmit data.

3. If any of these tests fail, check the following:

   • Verify that your terminal and operating system settings for the port agree. Specifically but not exclusively, look at flow control, baud rate, data bits, stop bits and parity.
   • Check your cable to see that it is wired correctly and that it is of sufficient quality.
4. If you make corrections in the previous step, retest the port. Enable the port for login again if necessary.
5. If you cannot get a test to pass, contact Digi Technical Support.