Use this procedure to enable and configure a Digi device with pmadm. This procedure can be used from a command line prompt in the absence of a window interface to the operating system. For additional information and help on pmadm, consult your Solaris documentation.
Enter a pmadm command at a root prompt. Here is
an example of a command that will enable a port for 9600 8,1,N. Modify the command
as necessary for your terminal.
pmadm -a -p zsmon -s a001s -fu -i root -v `ttyadm -V`
-m "`ttyadm -d /dev/term/a01s -l 9600 -s /usr/bin/login`"
where:
|
zsmon |
is the port monitor tag. Use a different one if appropriate. |
|
a001s |
is the name of the device. Refer to your Digi manual for your device names. |
|
-l 9600 |
sets the port for a baud rate of 9600. |
Verify that the port is enabled with this command:
pmadm -l