The following error messages may occur while the driver is parsing the parameters.
*Usage Error: AIODGXI port=XXXX mem=XXXXX [name=bname].
This error will appear if you load the driver with no parameters on ISA bus computers.
*Usage Error: First parameter not 'port='.
The driver expects the first parameter to be port=xxx, but this is not the case.
*Error: Invalid Port Address 0x310.
This message indicates that an invalid port address was specified.
*Error: Port Address 0x320 is already supported.
This message indicates that the driver is already supporting an adapter at this port address.
*Usage Error: Second parameter not 'mem='
The driver expects the second parameter to be mem=xxxxx, but this is not the case.
*Error: Invalid Memory Address 0xF0000.
This message indicates that an invalid memory address was specified.
The following error messages may occur while the driver is performing some initial tests on the adapter.
Adapter 4: Port 220 Mem D0000 Port 220 not found.
This message indicates that the driver could not find an adapter with port 220h. Check to insure that you have specified the correct I/O port or that you have properly configured the adapter's port address.
Adapter 4: Port 220 Mem D0000 Hardware Reset Fails.
This message indicates that the driver could not place the adapter into a reset state. This is most likely the result of an I/O port ad-dress conflict or a faulty adapter. Be sure that there are no other I/O ports in your system at the indicated I/O port address.
Adapter 4: Port 220 Mem D0000 Memory not found error x.
This message indicates that the driver could not find the adapter's memory. x indicates the number of memory errors found in a 256 byte block.
Adapter 4: Port 220 Mem D0000 Memory error x.
This message indicates that the driver has found the adapter's memory, but it appears to be faulty. x indicates the number of errors found in a 256 byte block.
The following messages may occur during the driver's attempt to initialize the adapter.
Adapter 4: Port 220 Mem D0000 BIOS fails initialization.
This message indicates that the adapter's on-board BIOS did not initialize properly.
Adapter 4: Port 220 Mem D0000 BIOS passes init but reports 0 ports.
This message indicates that the BIOS initialized successfully, but could not find any of the asynchronous channels.
Adapter 4: Port 220 Mem D0000 NMI Fails during FEPOS code move.
This message indicates a failure during transfer of the on-board operating system code.
Adapter 4: Port 220 Mem D0000 NMI Fails during FEPOS execution.
This message indicates a failure during startup of the on-board operating system.
Adapter 4: Port 220 Mem D0000 FEPOS Fails Initialization.
This message indicates that the on-board operating system did not initialize successfully.
Adapter 4: Port 220 Mem D0000 Command failure during Initialization.
This message indicates that the on-board operating system encountered a failure during initialization of the asynchronous channels.