Use the worksheet below to collect information that may be required to configure your DataFire PTE adapter in your operating system environment. Note that not all operating systems support all parameters.
The parameters on this page are for ISDN T1 (PRI) connected to a PBX or similar in-house network (Short Haul). If your adapter is connected directly to an external T1 telephone line, use the ISDN T1 (PRI), Long Haul (External T1) configuration worksheet.
| Parameter | Value |
|---|---|
| Coding | [ ] B8ZS |
| Framing | [ ] ESF |
| Short Haul Length (in feet) | [ ] 0-133 [ ] 133-266 [ ] 399-533 [ ] 533-655 |
| Address Type | |
| Numbering Plan | |
| Subaddress Type | |
| ISDN Switch Type or D Channel Protocol |
[ ] AT&T 5ESS [ ] Nortel DMS 100/250 [ ] ETSI (Euro ISDN) [ ] INS-1500 (Japan) [ ] National ISDN2 |
| Modem Nationality |
Enter the country in which the PTE adapter will be installed: |