Changing Adapter Properties

Use this procedure to change the configuration of an installed adapter.

Procedure

1. From the Start menu, choose Control Panel > System > Hardware > Device Manager.

   Note: If you have set the Windows XP Start menu to the "classic" mode, choose Settings > Control Panel > System > Hardware > Device Manager.

2. From the displayed list, choose one of the following, according to your adapter type:
• Multi-port serial adapters (for AccelePort asynchronous serial adapters)
• Network adapters (for DataFire synchronous, DataFire RAS, or AccelePort RAS adapters)
3. Choose the Digi adapter you wish to configure.
4. From the Action menu, choose Properties.
5. Configure the adapter as necessary.
6. If you changed the hardware resources from the default settings, Windows may notify you to restart the system to complete the configuration.

   If you left the hardware resources at their default values, the adapter is ready to use without restarting the system.