General SCO UnixWare Device Configuration

Use this information to configure serial ports, which includes configuring port direction (incoming and outgoing), transmission speed, and other port attributes.

Note:  Users without SCO UnixWare should use the procedures found in General SVR4 Device Configuration.

1. Start the SCO Serial Manager by entering this command at a SCO UnixWare command prompt:

   scoadmin serial

2. Configure the ports as needed. Use the SCO UnixWare online help for additional information.
3. Exit the SCO Serial Manager.

Note: There is a bug in the SCO UnixWare Serial Manager that causes it to incorrectly set the "o" and "P" ttymon flags for a RealPort modem port. If the port does not work for logins, you may need to remove these flags. Use the realport_pm_flags program to list all non-console ttymon port monitor flags and change them appropriately.