Planning Information

Note: Most of the following information is for RealPort and the Digi One RealPort or PortServer. For requirements and considerations for EtherLite, see Requirements and Considerations: EtherLite.

Requirements

• The RealPort driver requires between one and two MB of memory on the Microsoft Windows 2000 system.
• The Windows 2000 RealPort driver requires a 10-pin RJ-45 cable to connect devices to PortServer ports. 

Limitations

• Only TAPI-compliant applications or those written to COM 32 API (application programming interface) standards can use intelligent ports, which means only these applications can use RealPort ports.

Configuration Information

Before you begin the RealPort installation and configuration, gather the following information. Use the set config command to determine this information. 

• IP address and/or domain name of each PortServer involved in the RealPort configuration
• The ports on each Digi One RealPort PortServer that you intend to use for RealPort
• More information on setting up RealPort can be found at the following URL:
  http://supportold.digi.com/techsupport/hardware/portserver/psrpsetup.html

Peripheral Information

Before you can correctly cable a peripheral to a RealPort port, determine the peripheral's cabling and flow control requirements. See the peripheral's documentation for information and the Digi One RealPort and PortServer Cable Guide.

Key Concept: About Port Mapping Offsets

The number of local ports on the Windows 2000 host offsets the port number on the PortServer. For example, if you have two local COM ports, Port 1 of the Digi One RealPort or PortServer is seen by the RealPort service as COM 3.