reconnect

Use the reconnect command to re-establish a connection that was previously initiated with the connect command. The reconnect command is just like the connect command, except that no parameters are included. Instead, the connection is established using the parameters specified with the last connect command issued. Anyone can issue the reconnect command. 

To temporarily suspend a connect session, use the escape key defined by the ConnectEsc option of the set users command (default for root is CTRL-[). Use the close command to end the session.

Command Syntax

Enter the connect command as shown below:

reconnect

Command Example

Initiating a Connection

In this example, the connect command re-establishes the previous connection:

reconnect