Master Setup Process

Use this topic to identify all the tasks required to complete RealPort setup.

Procedure

1. Plan your RealPort setup. See Planning Information. 
2. Configure the Digi One RealPort or PortServer or the EtherLite for RealPort. Use the set config command for this purpose. See Configuring the Digi One RealPort or PortServer for RealPort or Configuring EtherLite for RealPort. 
3. Install and configure the RealPort driver. See Installing a Driver. If you are upgrading an installed driver to a newer version, see Upgrading the Driver.
4. Reboot the system to make RealPort ports available to the operating system.
5. Configure peripherals on the RealPort ports. See the following: Configuring a Printer on a Digi Port and Configuring a Modem on a Digi Port.