Table of Contents
- 1.1 Development Kit Contents
- 1.2 Development Software
- 1.3 How to Use This Manual
- 1.3.1 Additional Product Information
- 1.3.2 Additional Reference Information
- 1.3.3 Using Online Documentation
- 1.4 CE Compliance
- 1.4.1 Spectrum Spreader
- 1.4.2 Design Guidelines
- 1.4.3 Interfacing the BL1800 to Other Devices
- 2.1 Software Installation
- 2.2 Prototyping Board
- 2.2.1 Prototyping Board Features
- 2.3 Development Hardware Connections
- 2.3.1 Attach BL1810 to Prototyping Board
- 2.3.2 Connect Programming Cable
- 2.3.3 Connect Power
- 2.4 Start Dynamic C
- 2.5 Run a Sample Program
- 2.5.1 Troubleshooting
- 2.6 Where Do I Go From Here?
- 2.6.1 Technical Support
- 3.1 Running Sample Program DEMOJR1.C
- 3.1.1 Other Sample Programs Illustrating Digital I/O
- 3.1.2 RS-232 Serial Communication Sample Programs
- 3.1.3 RS-485 Serial Communication Sample Program
- 3.2 Cooperative Multitasking
- 3.2.1 Advantages of Cooperative Multitasking
- 3.3 Switching Between Program Mode and Run Mode
- 3.3.1 Detailed Instructions: Changing from Program Mode to Run Mode
- 3.3.2 Detailed Instructions: Changing from Run Mode to Program Mode
- 4.1 An Overview of Dynamic C
- 4.1.1 Upgrading Dynamic C
- 4.1.2 Add-On Modules
- 4.2 BL1810 Function Calls
- 4.2.1 I/O Drivers
- 4.2.2 Serial Communication Drivers
- A.1 Electrical and Mechanical Specifications
- A.2 Header Pinout
- A.3 Jumper Configurations
- A.4 Use of Rabbit 2000 Parallel Ports